Installing an expansion-card riser, 5 reconnect all cables – Dell POWEREDGE R515 User Manual
Page 118
118
Installing System Components
Installing an Expansion-Card Riser
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 To install an expansion-card riser, align the riser guides with the riser guide
posts on the system board. See Figure 3-18.
2 Lower the expansion-card riser into place until the expansion-card riser
connector is fully seated.
3 If applicable, reinstall the expansion card. See "Installing an Expansion
4 Reinstall the storage controller card. See "Installing the Storage Controller
5 Reconnect all cables.
6 Replace the cooling shroud. See "Installing the Cooling Shroud" on
7 Close the system. See "Closing the System" on page 85.
8 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
book.book Page 118 Tuesday, August 24, 2010 1:47 PM