Dell POWEREDGE R515 - Manual (Page 135)

Installing System Components 135
9 Press the battery toward the negative side of the connector and lift it out of
the securing tab.
10 Support the battery connector by pressing down firmly on the positive side
of the connector.
11 Hold the new battery with the "+" facing the plastic connector on the
system board and slide it under the securing tabs.
12 Press the battery straight down into the connector until it snaps into place.
13 Replace the expansion-card riser. See "Installing an Expansion-Card Riser"
on page 118.
14 Replace the storage controller card. See "Installing the Storage Controller
Card" on page 121.
15 Replace the expansion card from the expansion-card slot. See "Installing
an Expansion Card" on page 113.
16 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 87.
17 Close the system. See "Closing the System" on page 85.
18 Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
19 Enter the System Setup program to confirm that the battery is operating
properly. See "Entering the System Setup Program" on page 58.
20 Enter the correct time and date in the System Setup program's Time
and Date fields.
21 Exit the System Setup program.
book.book Page 135 Tuesday, August 24, 2010 1:47 PM