Figure 3-23. removing and installing the heat sink, Ws. see figure 3-23 – Dell POWEREDGE R515 User Manual
Page 130
Advertising
130
Installing System Components
Figure 3-23. Removing and Installing the Heat Sink
10 Rotate the processor shield upward and out of the way. See Figure 3-24.
11 Lift the processor out of the socket and leave the release lever up so that
the socket is ready for the new processor.
CAUTION:
Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
NOTE:
In single-processor configurations, a processor must be installed in socket
CPU1. Install the blank in socket CPU2 only.
1
heat sink
2
retention screws (4)
2
1
book.book Page 130 Tuesday, August 24, 2010 1:47 PM
Advertising