Figure 3-8. removing and installing a hard drive, Installing a hard drive, Figure 3-8 – Dell POWEREDGE R515 User Manual

Page 89

Advertising
background image

Installing System Components

89

Figure 3-8. Removing and Installing a Hard Drive

Installing a Hard Drive

CAUTION:

Use only hard drives that have been tested and approved for use with

the SAS/SATA backplane.

CAUTION:

When installing a hard drive, ensure that the adjacent drives are fully

installed. Inserting a hard-drive carrier and attempting to lock its handle next to a
partially installed carrier can damage the partially installed carrier's shield spring
and make it unusable.

CAUTION:

To prevent data loss, ensure that your operating system

supports hot-swap drive installation. See the documentation supplied
with the operating system.

CAUTION:

Combining SATA and SAS hard drives in the same system

configuration is not supported on all configurations.

1 If applicable, remove the front bezel. See "Removing the Front Bezel" on

page 82.

2 If a drive blank is present in the bay, remove it. See "Removing a

Hard-Drive Blank" on page 87.

3 Press the button on the front of the drive carrier.

1

release button

2

hard-drive carrier handle

1

2

book.book Page 89 Tuesday, August 24, 2010 1:47 PM

Advertising