Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 23)

BIOS Update Attempt Failed! Remote BIOS update
attempt failed.
Retry the BIOS update. Download the latest firmware from
the Dell Support website at support.dell.com.
CD-ROM drive not found Improperly
connected or missing
CD drive.
Ensure that the CD/diskette drive is properly installed. If the
problem persists, replace the CD/diskette drive (see
" CD/Diskette Drive ").
CPUs with different cache sizes
detected Microprocessors with
different cache sizes
are installed.
Ensure that all microprocessors have the same cache size
and that they are properly installed (see " Microprocessors ").
Decreasing available memory Faulty or improperly
installed memory
modules.
Ensure that the memory modules are properly installed. If
the problem persists, replace the faulty memory module(s)
(see " Memory Modules ").
Diskette drive n seek failure Incorrect
configuration settings
in the System Setup
program.
Run the System Setup program to correct the settings (see
" Using the System Setup Program ").
Faulty or improperly
installed diskette
drive.
Ensure that the CD/diskette drive is properly installed. If the
problem persists, replace the CD/diskette drive (see
" CD/Diskette Drive ").
Diskette read failure Faulty or improperly
inserted diskette.
Replace the diskette.
Diskette subsystem reset failed Faulty or improperly
installed diskette
drive.
Ensure that the CD/diskette drive is properly installed. If the
problem persists, replace the diskette drive (see " CD/Diskette
Drive ").
ECC memory error Faulty or improperly
installed memory
modules.
Ensure that the memory modules are properly installed. If
the problem persists, replace the faulty memory module(s)
(see " Memory Modules ").
Embedded server management
error
Embedded server management is
not present.
Embedded server
management
memory may be
temporarily
corrupted
To clear the embedded remote access memory, shut down
the system, disconnect the power cords, wait approximately
30 seconds, reconnect the power cords, and restart the
system. If the problem persists, replace the ERA/O card (see
" ERA/O Card ").
Error: Maximum PCI option ROM
count exceeded! Too many expansion
cards have ROM
enabled in the
System Setup
program.
Disable ROM for some of the expansion cards (see " Using the
System Setup Program ").
Gate A20 failure Faulty keyboard
controller; faulty
system board.
Replace the system board (see " System Board ").
Hard disk controller failure Incorrect
configuration settings
in System Setup
program; improperly
installed hard drive,
or loose interface or
power cable; faulty
hard-drive controller
subsystem.
Run the System Setup program to correct the drive type (see
" Using the System Setup Program "). If the problem persists,
ensure that the hard drives are properly installed (see " Hard
Drives "). If the problem persists, replace the system board
(see " System Board ").
Hard disk read failure
I/O parity interrupt at address Faulty or improperly
installed expansion
card.
Ensure that the expansion cards are properly installed. If the
problem persists, replace the faulty expansion card(s) (see
" Expansion Cards ").
Invalid configuration
information - please run SETUP
program Incorrect
configuration settings
in System Setup
program;
NVRAM_CLR jumper
is installed; faulty
system battery.
Check the System Setup configuration settings (see " Using
the System Setup Program "). Remove the NVRAM_CLR
jumper (see Figure 5-2 for jumper location). If the problem
persists, replace the system battery (see " System Battery ").
Invalid memory configuration