Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 33)

Removing the Control Panel
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of
the components inside the system. See your System Information Guide for complete information about
safety precautions, working inside the computer, and protecting against electrostatic discharge.
1. Remove the bezel (see " Removing the Bezel ").
2. Remove the system cover (see " Removing the Cover ").
3. Disconnect the control panel cable from the system board.
4. Remove the retaining screw that secures the control-panel assembly to the system chassis (see Figure 4-6 ).
5. Move the control-panel back and up, out of the front panel.
6. Lift the control panel and its cable completely out of the chassis (see Figure 4-6 ).
Replacing the Control Panel
CAUTION: Before you perform this procedure, read the safety instructions in your System Information
Guide.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information Guide.