Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 32)

The other end of this cable connects to the system board.
4. Disconnect any cables from any devices already installed in the peripheral bay.
5. Loosen the thumbscrew securing the back of the peripheral bay to the chassis.
6. Grasping the peripheral bay by its top handle with one hand and pressing the front of the peripheral bay, slide the
peripheral bay backward approximately 0.5-inch and lift up to remove the peripheral bay from the chassis.
Figure 4-5. Peripheral Bay Replacement
Replacing the Peripheral Bay
1. Holding the peripheral bay by its top handle, lower it into place and slide it forward approximately 0.5-inch (see
Figure 4-5).
The front panel of the peripheral bay, with its attached CD/diskette drive, must be flush with the front panel.
2. Connect the CD/diskette drive cable to the back of the interposer board.
3. Connect any cables you removed from any devices already installed in the peripheral bay.
4. Tighten the thumbscrew to secure the peripheral bay to the chassis (see Figure 4-5 ).
Control Panel
In Figure 4-6 , the control panel is shown removed from the system chassis.
Figure 4-6. Control-Panel Removal