Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 66)

9. Unpack the new microprocessor.
If any of the pins on the microprocessor appear bent, contact the source from whom you purchased the microprocessor.
10. Ensure that the release lever on the microprocessor socket is in the upright position.
11. Align pin 1 on the microprocessor (see Figure 4-29 ) with pin 1 on the microprocessor socket.
NOTE: No force is needed to install the microprocessor in the socket. When the microprocessor is aligned
correctly, it should drop into the socket.
12. Install the microprocessor in the socket (see Figure 4-29 ).
NOTICE: Positioning the microprocessor incorrectly can permanently damage the microprocessor and the system when
you turn on the system. When placing the microprocessor in the socket, be sure that all of the pins on the
microprocessor go into the corresponding holes. Be careful not to bend the pins.
13. When the microprocessor is fully seated in the socket, rotate the socket release lever back down until it snaps into
place, securing the microprocessor.
14. Place the new heat sink on top of the microprocessor (see Figure 4-28 ).
15. Orient the securing clips as shown in Figure 4-28 .
16. Hook the end of the clips without the latch to the tab on the edge of the socket.
17. Push down and pivot the securing clip latch until the hole on the clip latches onto the ZIF socket tab.
18. If you are adding a second microprocessor, you must install a VRM in the VRM 2 connector, pushing down firmly to
make sure that the latches engage (see Figure 4-30 ).
Figure 4-30. Installing the VRM