Console redirection screen, Exit screen – Dell PowerVault 770N (Deskside NAS Appliance) User Manual
Page 80
Option
Description
Password
Status
Setting the Setup Password option to Enabled prevents the system password from being changed or disabled
at system start-up.
To lock the system password, assign a setup password in the Setup Password option and then change the
Password Status option to Locked. In this state, you cannot change the system password using the System
Password option and cannot be disabled at system start up by pressing <Ctrl><Enter>.
To unlock the system password, enter the setup password in the Setup Password field and then change the
Password Status option to Unlocked. In this state, you can disable the system password at system start up
by pressing <Ctrl><Enter> and then change the password using the System Password option.
Setup
Password
Restricts access to the System Setup program in the same way that you restrict access to your system using the
system password feature.
NOTE:
See "
" for instructions on assigning a setup password and using or changing an
existing setup password.
System
Password
Displays the current status of your system's password security feature and allows you to assign and verify a new
system password.
NOTE:
See "
" for instructions on assigning a system password and using or changing
an existing system password.
Front-
Bezel
Chassis
Intrusion
Enables or disables the chassis-intrusion detection feature.
NOTE:
You can still turn on the system by using the power button, even if the Power Button option is set to
Disabled.
Power
Button
Turns system's power off and on.
If you turn off the system using the power button and the system is running an ACPI-compliant operating
system, the system can perform an orderly shutdown before power is turned off.
If the system is not running an ACPI-compliant operating system, power is turned off immediately after
the power button is pressed.
The button is enabled in the System Setup program. When disabled, the button can only turn on system power.
NMI
Button
NOTICE:
Pressing this button halts the operating system and displays a diagnostic screen.
Sets the NMI feature On or Off.
Console Redirection Screen
lists the options and descriptions for the information fields that appear on the Console Redirection screen. For
more information about using console redirection, see your System Administrator's Guide.
Table 6-5. Console Redirection Screen Options
Option
Description
Console Redirection
(On default)
Sets the console redirection feature to On or Off.
Remote Terminal Type
(VT 100/VT 220 default)
Select either VT 100/VT 220 or ANSI.
Redirection After Boot
(Enabled default)
Enables or disables console redirection after your system restarts.
Exit Screen
After you press <Esc> to exit the System Setup program, the Exit screen displays the following options:
Save Changes and Exit