Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 26)

Unsupported RAID key detected! RAID hardware key is
not supported by the
system.
Install the RAID hardware key for your specific system (see
" Integrated RAID Controller ").
The VRM for the processor in
socket n is not installed. Specified
microprocessor VRM
is faulty,
unsupported,
improperly installed,
or missing.
A VRM must be installed for each installed microprocessor.
Install a VRM for the specified microprocessor or remove the
VRM for the specified microprocessor if that microprocessor is
not installed (see " Microprocessors "). To identify the
microprocessors and VRMs, see Figure 5-2 .
Warning: Detected mode change
from RAID to SCSI B of the
embedded RAID subsystem. Type of controller
has changed since
previous system
boot.
Back up information on the hard drives before changing the
type of controller used with the drives.
Warning: Detected missing RAID
hardware for the embedded RAID
subsystem. Data loss will
occur! Press Y to switch mode
to SCSI, press any other key to
disable both channels. Press Y
to confirm the change; press
any other key to cancel.
Warning: Firmware is out- of-
date, please update. Firmware error. Update the firmware. Download the latest firmware from the
Dell Support website at support.dell.com.
Warning! No microcode update
loaded for processor n BIOS error. Update the BIOS firmware. Download the latest firmware
from the Dell Support website at support.dell.com.
Warning! System FRU is not
programmed Faulty or corrupt
data in NVRAM.
Ensure that the system board is properly installed and
configured. If the problem persists, replace the system board
(see " System Board ").
Write fault Faulty diskette,
CD/diskette drive
assembly, hard drive,
or hard-drive
subsystem.
Replace the faulty drive(s) (see " CD/Diskette Drive " and
" Hard Drives "). If the problem persists, replace the system
board (see " System Board ").
Write fault on selected drive
Warning Messages
A warning message alerts you to a possible problem and asks you to take corrective action before the system continues a
task. For example, before you format a diskette, a message may warn you that you may lose all data on the diskette.
Warning messages usually interrupt the procedure and require you to respond by typing y (yes) or n (no).
NOTE: Warning messages are generated by either the application program or the operating system. For more
information, see the documentation that accompanied the operating system or application program.
Diagnostics Messages
When you run a test group or subtest in system diagnostics, an error message may result. Diagnostic error messages are not
covered in this section. The message usually provides information for identification of the faulty component.
Alert Messages
The optional systems management software generates alert messages for your system. For example, the software generates
messages that appear in the SNMP trap log file. Alert messages consist of information, status, warning, and failure messages
for drive, temperature, fan, and power conditions. For more information, see the systems management software
documentation.
Back to Contents Page