Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 48)

Replacing the CD/Diskette Drive
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of
the components inside the system. See your System Information Guide for complete information about
safety precautions, working inside the computer, and protecting against electrostatic discharge.
1. Align the CD/diskette drive with the opening in the side of the peripheral bay.
2. Press the CD/diskette drive assembly firmly into the side of the peripheral bay and slide the assembly towards the back
of the peripheral bay until the release latch snaps into place (see Figure 4-18 ).
3. Replace the peripheral bay into the system chassis (see " Replacing the Peripheral Bay ").
4. Replace the system cover (see " Replacing the Cover ").
5. Replace the bezel (see " Replacing the Bezel ").
6. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
Chassis Intrusion Switch
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of
the components inside the system. See your System Information Guide for complete information about
safety precautions, working inside the computer, and protecting against electrostatic discharge.
1. Remove the front bezel (see " Removing the Bezel ").
2. Remove the system cover (See " Removing the Cover ").
3. Disconnect the chassis intrusion switch cable connector on the system board.
4. Grasp and slide the switch toward the center of the front panel until it comes free of its slot (see Figure 4-19 ).
Figure 4-19. Chassis Intrusion Switch Replacement