Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 47)

3. Reinstall any expansion cards that you removed (see " Installing an Expansion Card ").
NOTE: SCSI cables connected from an expansion card to the SCSI backplane board should be routed under the
front fan assembly.
4. Reinstall the front fan assembly (see " Replacing the Front Fan Assembly ").
5. Replace the cover (see " Replacing the Cover ").
6. Replace the bezel (see Replacing the Bezel ").
7. Connect a network cable to the 10-Mbps server management Ethernet connector on the system back panel.
8. Reconnect the system and peripherals to their electrical outlets, and turn them on.
CD/Diskette Drive
A CD/diskette drive assembly mount to the side of the peripheral bay and connects to the controllers on the system board
through a single ribbon cable to the system board.
Removing the CD/Diskette Drive
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of
the components inside the system. See your System Information Guide for complete information about
safety precautions, working inside the computer, and protecting against electrostatic discharge.
1. Remove the bezel (see " Removing the Bezel ").
2. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
3. Remove the peripheral bay from the system chassis (see " Removing the Peripheral Bay ").
4. Lift the CD/diskette drive release latch and slide the CD/diskette drive toward the front of the peripheral bay (see
Figure 4-18 ).
Figure 4-18. Removing and Installing the CD/Diskette Drive