Dell PowerEdge C8000 - Manual (Page 196)

196 Installing System Components
Installing the BMC Management Cable
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Locate the consolidated BMC cable connector on the system board. See
"System Board Connectors" on page 231.
2 Locate the LAN passthrough connector on the node power distribution
board. See "Node Power Distribution Board Connectors" on page 240.
3 Connect one end of the BMC management cable to the LAN passthrough
connector on the NPDB and the other end of the cable to the consolidated
BMC cable connector on the system board. See Figure 3-38.
4 Route the cable properly to prevent the cable from being pinched or
crimped.
5 Replace the hard-drive tray. See "Installing the Hard-Drive Tray" on
page 192.
6 Replace the internal hard-drives. See "Installing a Hard-Drive Carrier" on
page 189.
7 Replace the back cover. See "Installing the Back Cover" on page 151.
8 Replace the sled. See "Installing a Sled" on page 144.
1 BMC management cable on system
board
2 BMC management cable on node
power distribution board