Dell PowerEdge C8000 - Manual (Page 229)

Jumpers and Connectors 229
System Board V1.2 Jumper Settings
Figure 5-3. System Board V1.2 Jumper Settings
Table 5-3. System Board Jumper Settings
Item Jumper Setting Description
1 Service mode (default) The flash security setting is enabled.
The flash security and NVRAM clear
signal is disabled.
2 NVRAM clear (default) The configuration settings are retained at
system boot.
The configuration settings are cleared at
the next system boot.
3 ME firmware
recovery
(default) The ME firmware recovery jumper is
disabled.
The ME firmware recovery jumper
enables ME firmware recovery mode.
4 BIOS recovery (default) The BIOS recovery jumper is disabled.
The BIOS recovery jumper enables the
BIOS flash memory special recovery
mode.
2 3 4
5 6
1