Dell PowerEdge M600 - Manual (Page 185)

Ethernet Configuration Commands 153
mdix
Use the mdix command in Interface Configuration mode to enable cable crossover on a given
interface. To disable crossover, use the no form of this command.
Syntax
mdix {on | auto}
no mdix
• on—Manual mdix
• auto—Auto mdi/mdix
Default Configuration
Automatic crossover is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
In the following example, automatic crossover is enabled on gigabit Ethernet port 5 of unit 1.
console(config)# interface ethernet 1/g5
console(config-if-1/g5)# mdix auto
mtu
Use the mtu command in Interface Configuration mode to enable jumbo frames on an interface by
adjusting the maximum size of a packet. To return to the default setting, use the no form of this
command.
Syntax
mtu bytes
no mtu
• bytes —Number of bytes (Range: 1518-9216)
Default Configuration
The default number of bytes is 1518 (1522 bytes of VLAN-tagged frames).