Dell PowerEdge M600 - Manual (Page 321)

IP Addressing Commands 303
console(config-vlan1)#helper-address 131.108.1.27 30,100-120,201
interface out-of-band
Use the interface out-of-band command to bring up the OOB port configuration menu.
Syntax Description
interface out-of-band
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
No specific guidelines.
Example
console(config)#interface out-of-band
console(config-if)#
ip address
Use the ip address command in Global Configuration mode to set an IP address. To remove an IP
address, use the no form of this command.
Syntax
ip address ip-address {mask |prefix-length}
no ip address
• ip-address—Specifies a valid IP address.
• mask—Specifies a valid subnet (network) mask IP address.
• prefix-length—The number of bits that comprise the IP address prefix. The prefix length
must be preceded by a forward slash (/). (Range: 1-30)
Default Configuration
No IP address is defined for the switch management interface.
Command Mode
Global Configuration mode