Dell PowerEdge M600 - Manual (Page 642)

646 IPv6 Routing Commands
www
.dell.com | support.dell.com
loopback 2 Disabled
tunnel 1 Disabled 3FFE:1234::1/64 [TENT]
show ipv6 neighbors
Use the show ipv6 neighbors command in Privileged EXEC mode to display information about the
IPv6 neighbors.
Syntax
show ipv6 neighbors
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the IPv6 neighbors.
console(config)#show ipv6 neighbors
Neighbor Last
IPv6 Address MAC Address isRtr State Updated
Interface
-------------------- ----------------- ----- ------- ---------
show ipv6 route
Use the show ipv6 route command in Privileged EXEC mode to display the IPv6 routing table.
Syntax
show ipv6 route [{ipv6-address [ protocol] | {{ipv6-prefix/ ipv6-prefix-length | interface}
[protocol] | protocol [all] | all}]
• ipv6-address—Specifies an IPv6 address for which the best-matching route would be
displayed.