Dell PowerEdge M600 - Manual (Page 761)

PIM-SM Commands 769
PIM-SM Commands
ip pimsm
Use the ip pimsm command in Global Configuration mode to set administrative mode of PIM-SM
multicast routing across the router to enabled. IGMP must be enabled before PIM-SM can be
enabled.
Syntax
ip pimsm
no ip pimsm
Default Configuration
Disabled is the default state.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables PIM-SM on the router.
console(config)#ip pimsm
ip pimsm cbsrhashmasklength
Use the ip pimsm cbsrhashmasklength command in Interface Configuration mode to configure
the CBSR hash mask length to be advertised in bootstrap messages for a particular PIM-SM
interface. This hash mask length is used in the hash algorithm for selecting the RP for a particular
group.