Dell PowerEdge M600 - Manual (Page 570)

570 DHCP and BOOTP Relay Commands
www
.dell.com | support.dell.com
• ip-address—IP address of the BootP/DHCP Relay server
Default Configuration
0.0.0.0 is the default ip-address.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example defines the BootP/DHCP Relay server IP address.
console(config)#bootpdhcprelay serverip 192.168.30.3
show bootpdhcprelay
Use the show bootpdhcprelay command in User EXEC mode to display the BootP/DHCP Relay
information.
Syntax
show bootpdhcprelay
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example defines the BootP/DHCP Relay information.
console>show bootpdhcprelay
Maximum Hop Count.............................. 6
Minimum Wait Time(Seconds)..................... 0
Admin Mode..................................... Enable
Server IP Address.............................. 192.168.30.3