Show radius-servers – Dell PowerEdge M600 User Manual
Page 410
400
Radius Commands
www
.dell.com | support.dell.com
Default Configuration
The default number for attempts is 3.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before executing this
command.
Example
The following example of the retransmit command specifies five retries.
console(config)#radius-server host 192.143.120.123
console(config-radius)#retransmit 5
show radius-servers
Use the show radius-servers command in Privileged EXEC mode to display the Radius server
settings.
Syntax
show radius-servers
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the Radius server settings.
console#show radius-servers
IP address Auth TimeOut Retransmit DeadTime Source IP Priority Usage
---------- ----- ------- ---------- -------- -------- -------- -----
10.2.3.4 1812 6 Global Global 0.0.0.0 0 all
10.240.1.4 1812 Global Global 10 Global 0 all