Dell PowerEdge M600 - Manual (Page 561)

ARP Commands 561
console(config)#no arp dynamic renew
arp purge
Use the arp purge command in Privileged EXEC mode to cause the specified IP address to be
removed from the ARP cache. Only entries of type dynamic or gateway are affected by this
command.
Syntax
arp purge ip-address
• ip-address—The IP address to be removed from ARP cache.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example removes the specified IP address from arp cache.
console#arp purge 192.168.1.10
arp resptime
Use the arp resptime command in Global Configuration mode to configure the ARP request
response timeout. To return the response timeout to the default value, use the no form of this
command.
Syntax
arp resptime integer
no arp resptime
• integer—IP ARP entry response time out. (Range: 1-10 seconds)
Default Configuration
The default value is 1 second.
Command Mode
Global Configuration mode