Dell PowerVault NX3000 User Manual

Page 50

Advertising
background image

50

About Your System

Unable to launch

System Services

image. System

halted!

System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost
due to system board
replacement.

Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server Configuration
user documentation for more
information.

The iDRAC6 Enterprise card
flash memory may be
corrupted.

Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC6 user's guide for
instructions on performing a
field replacement of the flash
memory.

Unexpected

interrupt in

protected mode

Improperly seated memory
modules or faulty
keyboard/mouse controller
chip.

Reseat the memory modules.
See "Troubleshooting System
Memory." If the problem
persists, see "Getting Help."

Unsupported CPU

combination

Unsupported CPU

stepping

detected

Processor(s) is not supported
by the system.

Install a supported processor
or processor combination.
See "Processors."

Unsupported DIMM

detected. The

following DIMM

has been

disabled:

x

Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.

Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."

Unsupported

memory

configuration.

DIMM mismatch

across slots

detected:

x,x,...

Invalid memory
configuration. Memory
modules are mismatched in
the specified slots.

Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."

Table 1-2.

System Messages (continued)

Message

Causes

Corrective Actions

Advertising