Removing the internal sd module, Internal sd flash card, Installing the internal sd flash card – Dell PowerVault NX3000 User Manual

Page 89

Advertising
background image

Installing System Components

89

Removing the Internal SD Module

WARNING:

Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

2 Open the system. See "Opening the System."
3 Disconnect the cable from the internal SD module and from the control

panel board. See Figure 3-8.

4 Lift upwards on the latch securing the internal SD module to the chassis,

then lift the tray out of the chassis. See Figure 3-8.

5 Close the system. See "Closing the System."
6 Reconnect the system and peripherals to their power sources, and turn

them on.

Internal SD Flash Card

Installing the Internal SD Flash Card

WARNING:

Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.

NOTE:

To use an SD card with your system, ensure that the internal SD card port is

enabled in the System Setup program. See "Using the System Setup Program and
UEFI Boot Manager."

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

2 Open the system. See "Opening the System."
3 Locate the SD card connector on the internal SD module and, with the

label side facing up, insert the contact-pin end of the card into the slot.
See Figure 3-8.

NOTE:

The slot is keyed to ensure correct insertion of the card.

4 Press the card into the card slot to lock it into place.
5 Close the system. See "Closing the System."

Advertising