Dell PowerVault NX3000 - Manual (Page 93)

Installing System Components
93
Removing an iDRAC6 Enterprise Card
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System."
3 If installed, remove all expansion cards from expansion-card riser 1. See
"Removing an Expansion Card."
4 Remove the VFlash media card (if installed) from the iDRAC6 Enterprise
card. See "VFlash Media (Optional)."
5 If present, disconnect the Ethernet cable from the iDRAC6 Enterprise
card.
6 Remove the iDRAC6 Enterprise card:
a Pull back slightly on the two tabs at the front edge of the card and
gently lift the front edge of the card off of the retention standoffs.
b As the card releases from the standoffs, the connector under the card
disengages from the system board connector.
c Slide the card away from the back of the system until the RJ-45
connector is clear of the back panel, then lift the card out of the
system.
7 Install the plastic filler plug for the vacated RJ-45 Ethernet port in the
system back panel.
8 Reinstall the expansion card(s) in expansion-card riser 1. See "Installing an
Expansion Card."
9 Close the system. See "Closing the System."
10 Reconnect the system and peripherals to their power sources, and turn
them on.