SINGER XL-420 FUTURA - Manual (Page 96)

94
Send design / Envoyer le dessin / Envie el diseño
7. Once point A is entered, the screen will prompt you to
enter in points B and C. Follow the same procedures for
inputting points B and C.
 :KHQ DOO WKUHH SRLQWV KDYH EHHQ HQWHUHG WKH 0DFKLQH
1DYLJDWRU %R[ ZLOO DSSHDU &OLFN RQ 6HQG GHVLJQ LQ WKH
0DFKLQH1DYLJDWRU%R[WRVHQGGHVLJQSRUWLRQRIGDWD
to the machine. Embroider the design.
9. After all colors of the design from hoop 1 have been
HPEURLGHUHGFOLFNRQ([LWLQWKH0DFKLQH1DYLJDWRUER[
and the screen will prompt you to enter the information
from the data 2 area. Use the same procedure to re-
hoop the fabric, send the data 2 design to the machine
and input the A, B and C points. The buttons on the
machine will once again be lit to indicate the “cross line”
SRVLWLRQV LQ WKH KRRS  DQG WKH EXWWRQ WKDW LV EOLQNLQJ LV
indicating the point to be input. Embroider the data 2
design.
10. Follow this procedure for the data 3 and data 4.
In a case where the three points were input wrong,
and they do not form an exact right angle, the software
will show the following error message and give you an
opportunity to enter the alignment points again.