Cub Cadet 8454 User Manual

Page 163

Advertising
background image

TRANSMISSION SYSTEM

4-59

D569-W03 June-2003

A. DIFFERENTIAL LOCK ASSEMBLY

a . To Disassembling

1. Remove spring pin (7).

2. Take out snap pin (3) and Disassembling plane

washer and pin (2).

3. Take out differential lock fork shaft (4) and remove

differential lock fork (1).

b. To Assemble

1. Install oil seal (6) on both sides of the transmis-

sion case and apply grease on the lip area.

2. Insert differential lock fork (1) into differential lock

shift (8).

3. Insert washer (5) into differential lock fork shaft (4)

to tighten differential lock fork (1) through the side
hole of the transmission case.

4. Fix spring pin (2), plane washer and snap pin (3).

5. Insert plane washer into the outside of the trans-

mission case and fix two spring pins (7).

B. FRONT WHEEL DRIVE

a . To Disassembling

1. Remove snap ring (5) on the transmission case.

2. Slightly knock front wheel drive shaft (1) at the back

of the transmission case to remove at a time with
6305 ball bearing (4).

b. To Assemble

1. Install 6305 ball Bearing (4) on the transmission

case.

2. After sub-assembly of snap ring (3) on front wheel

rive shaft (1), push through the assembled area and
insert into the spline of 34 gear (2) to fix front wheel
drive shaft (1) with 6305 ball bearing (4).

3. After installing 6305 ball bearing (4) on the as-

sembled area of the middle case and front wheel
drive shaft (1), fix the middle case with hole snap
ring (5) and tighten 6305 ball bearing (4).

4. Install snap ring (6) on the end of front wheel drive

shaft (1).

(1) Differential Lock Fork

(2) Spring Pin

(3) Snap Pin

(4) Differential Lock Fork Shaft

(5) Washer

(6) Oil Seal

(7) Spring Pin

(8) Shift

(1) Front Wheel Drive Shaft

(2) 34 Gear

(3) Snap Ring

(4) Ball Bearing

(5) Snap Ring

(6) Snap Ring

569W495A

569W496A

Assembling direction of the oil seal
shall allow the lip area to be located
inside the transmission case.

CAUTION

Advertising