Cub Cadet 8454 - Manual (Page 322)

CHAPTER 9 8454
9-8 D569-W02 May-2003
2. HEATER
2.1 STRUCTURE
2.2 DISASSEMBLY AND ASSEMBLY
1. Open drain cock in right of front axle frame and drain
coolant.
2. Remove heater hose connected to connecting plate
1, 2 and heater assembly using clamp.
3. Disconnect duct hose and wiring connected to heater
assembly. Disengage 4 M8 nuts and remove heater
assembly.
Precautions When Assembling
1. Be careful not to be distorted when connecting with
hose.
2. Tighten firmly with clamp to prevent water leakage
when connecting with hose.
2.3 HEATER OPERATION DEVICE
Heater switch is operated in two stages of High and
Low. Heater operation makes the temperature in cabin
controllable through increasing and decreasing the
level of coolant circulated in engine. Ventilating hole
moves in right, left, front and rear and can control the
direction of air into cabin freely.
Hot water type
HI: 2170 kcal/h
Low:1900 kcal/h
Hi: 230 m 3 /h
Low:130 m 3 /h
Less than 65 W (DC12 V)
8.9 , 2.4 U.S.gal
HFC-134 A
0.95 ~ 1.0 kg, 2.1 ~ 2.2 lbs
VCON488
150 CC
Item 8454
Heater
Air conditioner
Type
Radiating (kcal/h)
Air flow
Power consumption
Coolant Capacity
Used refrigerator
Level of refrigerator
Compressor oil (compressor)
Level of oil (compressor)
569W915A
(1) Heater Switch