Cub Cadet 8454 - Manual (Page 259)

HYDRAULIC SYSTEM
6-65 D569-W02 May-2003
d. To Assemble the Relief Valve
1. Pick up the spring guide part with a pin set to insert
poppet (25) into the flange area of the housing.
2. Insert spring (26) and damper collar (27).
3. Insert O-ring into the relief adjusting plug (29) to
tighten with the housing.
(25) Poppet (29) Adjusting Plug
(26) Spring (33) Screw
(27) Damper Collar (34) Retainer Plate
(28) O-Ring (35) Ball
569W695A
• Adjust pressure of the steering relief
v a l v e w h e n t h e a s s e m b l y i s
completed.
Variable amount of pressure per revo-
lution of the relief adjusting plug (29)
is 15 kgf/cm
2 (213 psi).
CAUTION
e . Caution for Assembly of the Power Steer-
ing Unit
1. Be careful not to allow damages on the mechanically
processed ends of the sleeve, spool and housing.
2. Perform disassembly and repair at a clean place,
and remove any dust or foreign substance on joints
around the main body of the product with a wire
brush.
3. Be thoroughly careful not to cut of damage any parts
by body drop or contact when handling.
4. Disassembly of the power steering unit shall be as
specified in this manual, however not recommended
to if possible.