Cub Cadet 8454 - Manual (Page 226)

CHAPTER 6 8454
6-32 D569-W03 June-2003
H. DOUBLE ACTING VALVE
a . To Disassembling
1. Remove O-rings (7), (8).
2. Remove Roller (25) and pin (18) and then Disas-
sembling bent arm (24) and ring (26).
3. Remove 2 screws, gasket (13) and cover (12) and
then loosen bolt (11), and washer (10) on the cover.
4. Remove spacer (17), spring (15) and valve (14).
5. Loosen nut (6) and cover (5).
6. Disassembling spool (28), washer (29), spring (30),
spacer (32) and adjusting screw (31) ass’y.
7. Loosen plug (19) without causing damage on the
O-ring.
(1) Double Acting Valve Ass’y (9) Valve
(2) Valve Body (10) Spring
(3) Spool (11) Valve Sheet
(4) O-Ring (12) Valve
(5) Washer (13) Spring
(6) Spring (14) Spacer
(7) Spacer (15) Gasket
(8) Adjusting Screw (16) Cover
(17) Screw (24) Roller
(18) Screw (25) Plug
(19) Nut (26) O-Ring
(20) Lock Washer (27) Pin
(21) Nut (28) O-Ring
(22) Ring (29) O-Ring
(23) Bent Arm (30) Plug
b. To Assemble
1. Clean with detergent oil thoroughly not to allow any
foreign substance in when assembling.
2. Apply grease sufficiently inside when assembling
bent arm (24) and plug (19).
• Pay attention to gasket (13) and cover
which might fly away due to the spring
tension when dismantling the Screw.
• Take out the valve body as erected
when dismantling valve (16).
• Be careful not to cause damage on the
spool.
CAUTION
569W643B