Inovonics TapWatch 3 - Manual (Page 15)

TapWatch Software Installation
05855E 14
2.2 Recommended System Requirements
Following are the recommended performance levels to ensure optimum
performance of the TapWatch 3 software.
• PC with 2 gigahertz processor
• 1 GB RAM if running Windows
®
XP
®
; 2 GB RAM if running Windows 7
®
• 2 GB of available hard disk space
2.3 Software Installation
To install TapWatch 3:
1. Double click the TapWatch3-Setup.exe.
2. If you get a warning that the publisher could not be verified, click Run.
3. If you get a notice that an unidentified application wants to access your
computer, click Allow.
4. If you are prompted to reboot your computer during installation, the
installer should restart after the reboot. If the install does not run again, it
will pick up where it left off automatically.
Note: Each time you start TapWatch 3 it will check to see if there is a software update
available. If there is, you will be prompted to update your software.
2.4 Setting Up the TapWatch 3 Software with Your Network
During installation of the TapWatch 3 software, you will need to set up the
TapWatch 3 software with your network to ensure only authorized users can
access your network.