Inovonics TapWatch 3 - Manual (Page 49)

Site Information
05855E 48
4.7 Toolbox
The toolbox screens provide troubleshooting and maintenance tools for your
EchoStream TapWatch system. There are two toolbox screens: the com port
sniffer screen and the check-in monitor screen.
4.7.1 Com Port Sniffer
Figure 4-9 Com Port Sniffer Screen
The Com Port Sniffer screen displays RF messages from registered
transmitters and repeaters as they are received by the receiver when Enable
RF is active. It is most commonly used during field troubleshooting to test the
RF backbone of the EchoStream Commercial Mesh Network.
4.7.1.1 Repeaters Only
Select this to show only repeater messages as they are received by the RF
gateway.
4.7.1.2 Transmitters Only
Select this to show only transmitter messages as they are received by the RF
gateway.