Inovonics TapWatch 3 - Manual (Page 54)

Site Information
05855E 53
4.7.2.3 Unit
Displays the unit for the registered device.
4.7.2.4 Util Type
Displays the type of utility for which the transmitter is providing the read.
4.7.2.5 Read
Displays the total number of the transmitter’s pulse counts.
4.7.2.6 TXID
Displays the unique identification number of the repeater or transmitter that
sent the message.
4.7.2.7 Status
Displays the status of the transmitter that sent the message.
• OK - indicates the transmitter is operating as it should be.
• B - indicates a low battery.
• I - indicates the transmitter is inactive.
• T - indicates the transmitter has been tampered with.
• R - indicates the transmitter has been reset.
4.7.2.8 Sgl Level
Displays the signal level of the message as measured by the RDL8500.
4.7.2.9 Sgl Margin
Displays the signal margin of the message as measured by the RDL8500.
4.7.2.10 Synchronize Data with the Data Logger
Data synchronized includes meter reads, site configuration, and exceptions.
Newer data always overwrites older data, so be sure you are not overwriting
changes made on the other end of the synchronization. The easiest way to
make sure of this is to perform a synchronization before making any changes,
ensuring that you start with the newest data in your software and data logger.
• If you are performing a synchronization where there are site configuration
updates in either TapWatch 3 or the data logger, TapWatch 3 will
recommend whether to click Publish or Retrieve. In most cases, the
recommended action is the correct one.