KEYENCE IB Series - Manual (Page 80)

4-2 Basic Settings and Advanced Settings
4-28
4
Set
ting V
a
rious
F
unct
ions
IB-E
The upper and lower limits for the different selections of analog outputs are as follows.
Upper limit setting screen and lower limit setting screen
When set to the default state [dEFLt], the following screens will be skipped.
When set to free range, the upper limit setting and lower limit setting screens will appear.
Press the  /  button on each setting screen to specify the upper limit and the lower limit.
" 1. Measurement Mode" (page 4-8)
Analog output accuracy
The analog output can be selected from ± 5 V, 1-5 V, 0-5 V or 4-20 mA.
*1 The averaging is as follows after 512 times.
512 times: Sampling rate x 2
1024 times: Sampling rate x 4
2048 times: Sampling rate x 8
4096 times: Sampling rate x 16
Analog setting Output upper limit Output lower limit
OFF Not output
0-5v 5V 0V
-5-5v 5V - 5V
1-5v 5V 1V
AMPR 20mA 4mA
Item Measurement mode Setting range Default value
Upper limit
% mode - 999.99 to 999.99 100.00
Dimension mode - 99.999 to 99.999 10.000
Lower limit
% mode - 999.99 to 999.99 0.00
Dimension mode - 99.999 to 99.999 0.000
(TGG
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
 #P)
GO
HOLD CALC CHECK

LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
#P* HOLD CALC CHECK

LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
#P. HOLD CALC CHECK
F'(.V
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
 KP
GO
HOLD CALC CHECK
9. Analog output
scaling
Upper limit
specifying screen
[MODE]
or  [MODE]
or 
10. External
input
[MODE]
or 
Lower limit
specifying screen
Voltage output Current output
Output range ± 5 V (Full scale 10 V) 4 - 20 mA (Full scale 16 mA)
Output resistance 100 Ω —
Maximum load resistance — 350 Ω
Repeatability ± 1 mV ± 1.5 μA
Accuracy in respect to display ± 0.05% of F.S. ± 0.25% of F.S.
Temperature characteristics ± 0.005% of F.S./± °C ± 0.01% of F.S./ °C
Refresh rate
*1
Same as sensor head sampling rate
Response delay time Same as response time (judgment output)
Time constant 10 μS (90% response) 30 μS (90% response)