KEYENCE IB Series - Manual (Page 97)

4-3 Calibration Function
4-45 IB-E
4
Set
ting V
a
rious
F
unct
ions
Setting Method (Logical Correction)
Point
Logical correction cannot be set if “dimension mode” is selected for
“1. Measurement Mode”.
Main screen
1
Press the [MODE] and  buttons for approx. 2
seconds on the main screen at the same time.
[30.CLb] is displayed on the main display (upper level).
Press the [MODE]
+  buttons for 2
seconds or more
at the same time
2
Press the  /  button to set [LoGic] and press the 
button.
3
Enter “R.V. before calibration (1)” on the main display
using the  /  buttons. The “R.V. before calibration
(1)” blinks on the main display (upper level). [SET1] is
displayed on the sub display's screen (lower level).
4
Press the [SET] button.
[set1] and the “R.V. you wish to display (1)” are alternately
displayed on the sub display's screen (lower level).
[SET] button
set2
5
Enter “R.V. you wish to display (1)” on the main
display using the  /  buttons.
6
Press the [SET] button. (SET1 confirmation operation)
After [set1] blinks several times on the sub display's screen
(lower level), [set2] is displayed. [SET] button

LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
 HOLD CALC CHECK
F'(.6
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
%.D
GO
HOLD CALC CHECK
Calibration setting
Setting value Description Default value
defLt
No correction (Default setting) 
MEAS
Measured correction
LoGic
Logical correction
5'6
LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
 HOLD CALC CHECK
R.V. before calibration (1)
" 1. Measurement Mode" (page 4-8)
Item Setting range Default value
R.V. before
calibration (1)
- 999.99 to 999.99 0.00

LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
 HOLD CALC CHECK
R.V. you wish to display (1)
" 1. Measurement Mode" (page 4-8)
Item Setting range Default value
R.V. you wish to
display (1)
- 999.99 to 999.99 0.00