KEYENCE N-410 - Manual (Page 131)

7-15
7-3 Settings
PLC
Link
7
KV Series Settings
 N-410 Settings
Make the following settings through the connected PLC.
 KV-10/16/24/40, KV-700/1000-3000 and KV-P Series
(direct connection to programmable controller port) Settings
No settings are required.
 KV-L20R Settings
(Switch)
(Unit editor)
Item Specification
Connected PLC KV Programmable controller port, KV-L20V
PLC type selection KEYENCE KV Series
Station number 0
Baud rate 9600 bit/s
Data bits 8 bit
Parity Even
Stop bit length 1 bit
Item Specification
Port 2 switch RS-232C *When using port 2 on a KV-L20 (V)
Port 2 terminator OFF *When using port 2 on a KV-L20 (V)
Item Specification
Operation mode KV mode (host link)
Interface RS-232C
Station number 0
Baud rate 9600 bit/s
Bit length 8 bit
Parity Even
Stop bit length 1 bit
Checksum Disabled
RS/CS flow control None