AERCO XPC GATEWAY Communications - Manual (Page 25)

GF-122 AERCO XPC GATEWAY
25
1.10.4 LON to AERCO XPC (with SLTA)
LON TO AERCO XPC (with SLTA)
XPC Port 2:
•
Wire SLTA to XPC Port 2  “TX” to “RX”, “RX” to “TX”, “Gnd” to “Signal Ground”, and Shield connected at one end only.
•
Place 4-position jumper on EIA-232 (two top rows);
•
Place 2-position jumper on 2W;
•
Jumper “DTR” and “DCD” on SLTA port (port 2).
8-Position Dipswitch:
•
Dipswitch 1,2 = On, Off (38.4 K baud);
•
Dipswitch 3 = On (B.A.S. on port 2);
•
Dipswitch 4 = Off;
•
Dipswitch 5-8 = On, Off, On, On (for Lon SLTA).
Rotary Address Switches:
•
Not applicable in this case.
Note: Lon XIF files are on enclosed CD or downloadable from “www.aerco.com”.
BE SURE TO CYCLE AERCO XPC POWER AFTER MAKING ANY DIPSWITCH OR JUMPER CHANGES.
AERCO XPC
LON
Port 2 Port 1a Ftt -10a
BAS
Lo
n
SLTA
Net
Ftt-10a
R
S
232
RS232
RS232