Gf-122 aerco xpc gateway – AERCO XPC GATEWAY Communications User Manual

Page 87

Advertising
background image

GF-122 AERCO XPC GATEWAY

87

•

Set the Communication mode for Port 1 using DIP Switch

4.

NOTE

When using Port 1b with the LonWorks Option Card, Port 1a cannot be
used.

4.

Set the Comm Selector DIP Switches 5 through 8 for LonWorks Option Card. The following example
shows the DIP Switches set for 38.4k baud, Port 1b, and LonWorks Option Card.

5. Connect LON Port to the LonWorks Option Card with the supplied ribbon cable.

NOTE

LonWorks Option Card must be OFF before being connected.

6. Set the Communications Selection jumpers to EIA-485 2-wire.

7. Turn on the XPC's power.

Advertising
See also other documents in the category AERCO Equipment: