FingerTec FMM-100 - Manual (Page 22)

22
Below is the table for ease of setting.
Types 1:N 1:1
High Security 45 25
Normal 35 15
Low Security 25 10
• FP Sensor Sensitivity: You can set the sensitivity of the fingerprint prism to respond to the
employee when he/she places finger on it. The default value is set at Medium. However,
when the environment is dry, it is recommended to set the sensitivity to high and set to
low if the environment is humid.
• 1:1 Retry Times: You can set the maximum number of attempts for 1:1 fingerprint veri-
fication or password verification. The device will trigger an alarm system when the limit
has been reached.
• Fingerprint Algorithm: You may choose to use either VX9.0 or VX10 for fingerprint algo-
rithm.
Note: Both algorithms are not compatible with each other.
• Fingerprint Image: You can select to display or not to display the fingerprint image dur-
ing verification or enrolment.
Reset Options
In an event you want to restore the terminal back to the factory settings, you can do so by
going to Menu
> Systems > Reset > Press OK to enter. A confirmation window will prompt
you before the terminal is reset. Ensure that you are certain of performing the task before
proceeding to avoid irreversible data loss.