Flintec FT-13 - Manual (Page 10)

FT-13 Technical Manual, Rev. 1.40 March 2013 Page 10 of 56
4.2.2 Standard Load Cell Connection
The load cell wiring should be made carefully before energizing to avoid damages to the weight indicator and
the load cells. The input resistance of the load
cells that you want to connect should be more than 58 Ω.
The sense pins of the instrument should be connected. In 4-wire installations the sense and excitation pins with
the same polarity should be short circuited at the connector side.
6-wire Load Cell
Connection
4-wire Load Cell
Connection
Pin no. for desk type & panel
type (D-Sub, 9-pin, female)
Pin no. for Stainless steel
housing (J12 connector)
+ Excitation + Excitation 1 1
+ Sense + Excitation 2 2
Shield Shield 3 4
- Sense - Excitation 4 6
- Excitation - Excitation 5 7
+ Signal + Signal 7 3
- Signal - Signal 8 5
Shield Shield Connector body 4
4.2.3 Digital I/O Connections
FT-13 is equiped with a digital I/O board which provides 4 digital inputs and 8 digital outputs.
The meanings of the various I/O depend on the selected standard filling programme (see chapter 7).
Definition Pin no.
(P*)
Pin no. (SS**)
Programme
J10, J15
(Standard)
JR1 & JR2
(Option)
0 1 2 3 / 6 4 5 7 8
GND 2
GND
(J15)
15
+24 V 1
24V
(J10)
16
Input 1 9 1 (J15) 12 Start of filling
Input 2 10 2 (J15) 11 -
Valve
is
down
Valve is
at middle
position
Start of discharge -
Clamp is
closed
Input 3 11 3 (J15) 10 - -
Valve is
down
Gate is closed
Clamp
is
closed
Gate is
closed
Input 4 12 4 (J15) 9 Reset
Output 1 3 1 (J10) 8 Coarse feeding
Output 2 4 2 (J10) 7 Fine feeding
Output 3 5 3 (J10) 6 -
Valve
down
Valve
down
Emtying
Dis-
charge
Charge
feed
-
Open the
gate
Output 4 6 4 (J10) 5 End of filling/emptying
Output 5 7 5 (J10) 4 - -
Valve is
up
End of discharge
Catch
the
clamp
End of
Emptying
/
Vibration
output
Output 6 8 6 (J10) 3 Error
Output 7 25 7 (J10) 2 -
Vibra-
tion
Release
the
clamp
Output 8 13 8 (J10) 1 Mid-feeding - Mid-feeding
Shield
Connector
body
Housing -
P*: for Panel type housing; SS*: stainless steel housing
Voltage Current
Digital input 20 to 28 V DC Max. 30 mA
Digital output 20 to 28 V DC Max. 300 mA (sum of all 3 outputs)