Flintec FT-13 - Manual (Page 24)

FT-13 Technical Manual, Rev. 1.40 March 2013 Page 24 of 56
7.3.6 Programme 5: Charging and Discharging
F T -1 3 F T -1 3
Application:
Weigh-in / Weigh-out systems
Weighing of sticky and viscose materials
Operation:
The tank/hopper is coarsly filled up to the filling
target. Afterwards it is discharged to the target
value by the discharge input in a 2-speed
discharging process.
Filling and discharging must be sequential.
Process Parameters Description
+ + +
When type FT- 13 is in the “Ready” status (the top LED in
the LED bar is “on” ) press the keys shown on the left
sequentially.
The period for the [dSChrG ] message is shown after the
discharging. It can be set up to 25.0 s.
“Gate position check”
0 = No
1 = “Gate position control” is enabled
The filling target value.
Exit
Process Messages Description
It is displayed during charging.
It is shown at the end of the discharging alternately to the
weight value.
This message is shown after discharging.
ChArGE
FULL XXXXX
F_ trGt XXXXX
d_
∩SG
X
GAtE_Ch X
dSChrG