Ram Trucks 2015 3500 - Owner Manual - Manual (Page 202)

The ParkSense® switch LED will be ON when
ParkSense® is disabled or defective. The ParkSense®
switch LED will be OFF when the system is enabled.
If the ParkSense switch is pushed, and the system is
disabled or requires service, the ParkSense switch LED
will blink momentarily, and then the LED will be ON.
Service The ParkSense® Rear Park Assist
System
During vehicle start up, when the ParkSense® Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display the ЉPARKSENSE
UNAVAILABLE WIPE REAR SENSORSЉ or the
Љ
PARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
message. Refer to “Electronic Vehicle Information Center
(EVIC) or Driver Information Display (DID)” in “Under-
standing Your Instrument Panel” for further information.
When the shift lever is moved to REVERSE and the
system has detected a faulted condition, the EVIC/DID
will display the ЉPARKSENSE UNAVAILABLE WIPE
REAR SENSORSЉ or the ЉPARKSENSE UNAVAILABLE
SERVICE REQUIREDЉ message for as long as the vehicle
is in REVERSE. Under this condition, ParkSense® will
not operate.
If ЉPARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ
appears in the Electronic Vehicle Information Center
(EVIC) or Driver Information Display (DID) make sure
the outer surface and the underside of the rear fascia/
bumper is clean and clear of snow, ice, mud, dirt or other
obstruction, and then cycle the ignition. If the message
continues to appear, see an authorized dealer.
If ЉPARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
appears in the EVIC/DID, see your authorized dealer.
200 UNDERSTANDING THE FEATURES OF YOUR VEHICLE