Stabilizer/sway bar system — power wagon only, Stabilizer/sway bar system — power, Wagon only – Ram Trucks 2015 3500 - Owner Manual User Manual

Page 535

Advertising
background image

To lock the front axle; move the axle locker switch to

FRONT/REAR LOCK while traveling less than 3 mph

(5 km/h). The indicator light will be solid when the front

axle is locked.
NOTE:

The rear axle must be locked before the front axle

will lock.
To unlock the front axle; move the axle locker switch to

REAR LOCK. The FRONT/REAR LOCK indicator light

will go out when the axle is unlocked.
NOTE:

The axle lockers could be torque locked due to

side to side loads on the axle. Driving slowly while

turning the steering wheel from a left hand turn to a right

hand turn or driving in REVERSE for a short distance

may be required to release the torque lock and unlock the

axles.

To unlock the rear axle; move the axle locker switch to

AXLE UNLOCK. The REAR LOCK indicator light will go

out when the rear axle is unlocked.

STABILIZER/SWAY BAR SYSTEM — POWER
WAGON ONLY

Your vehicle is equipped with an electronic disconnecting

stabilizer/sway bar. This system allows greater front

suspension travel in off-road situations.
Due to the use of taller springs, this vehicle has an

increased ride height of approximately 1.9 in (48.3 mm)

in the front and 1.5 in (38.1 mm) in the rear. A major

advantage to increasing ride height is the positive effect

it has on approach/departure and break over angles.
This system is controlled by the electronic control sway

bar switch located on the instrument panel.

5

STARTING AND OPERATING 533

Advertising
This manual is related to the following products: