Changing needle, To check the needle – Sears 385.4052LX200 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing Needle
Raise the needle by turning the handwheel toward you and
lower the presser foot.
Loosen the needle clamp screw by turning it counterclockwise.
Remove the needle from the clamp.
Insert the new needle into the clamp with the flat side away
from you.
When inserting the needle into the clamp, push it up as far as
it will go and tighten the clamp screw firmly with the screwdriver.
* Check your needles frequently for barbed or blunted points.
Snags and runs in knits, fine silks and silk-like fabrics are
permanent and are almost always caused by a damaged
needle.
To check the needle
Place the flat side of the needle on something flat (needle
plate, glass etc.). The clearance between the needle and flat
surface should be consistent. Never use a bent or blunt needle.
/ / / / / / / r
12