Threading the bobbin case – SINGER 2112 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Bobbin Case
* Hold bobbin so that thread unwinds in a
counter-clockwise direction, as shown, and place
bobbin in bobbin case (1).
5k Pull thread into notch (2), draw it back
under the tension spring (3), and back into
5k Draw approximately 4 inches (10 cm.) of
thread across the bobbin.
5k Close slide plate allowing the thread to enter
the slot between the needle plate and slide plate.