Cleaning and caring for the machine, Removing face plate, Cleaning the machine – SINGER 2112 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. CLEANING AND CARING FOR THE MACHINE
To ensure reliability, regularly clean and lubricate machine. Periodic check-ups by an autho
rized service center are recommended depending upon frequency of use.
Removing Face Plate
CAUTION: Before attempting any procedures
in this chapter, disconnect powerline plug from
Only remove the face plate of the machine for
cleaning, lubricating, and light bulb replacement.
Keep securely fastened at all other times.
^ Loosen and remove screw (1).
^ Remove face plate by drawing it slightly
towards the operator and then to the left (2)
5k Replace face plate by sliding it to the right
under top edge of arm top cover (3) and
5k When snugly seated, replace and tighten
Cleaning the Machine
5k For normal external cleaning, use a soft dry
cloth. Stubborn stains may be removed with a
mild soap and water solution.
5k Using a soft brush, remove all lint from
exposed mechanical parts under face plate as
well as thread path and needle, feed, and bob
5k Periodically, apply a drop of oil to areas
shown. DO NOT over oil!