Connecting the controller, Running the machine, Getting ready to sew – SINGER 2112 User Manual
Page 8: Connecting the machine
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. GETTING READY TO SEW
To really enjoy sewing, get to know the machine well. This chapter will be valuable in
doing just that.
Connecting the Machine
Connecting the Controller
NOTE: Before plugging in the machine, be sure
the electrical information on the label (1) below
the handwheel agrees with the local electrical
Push plug (2) into the receptacle (3) at the right
end of the machine. Then, connect plug (4) to
an electrical outlet.
Running the Machine
To turn on machine and sewing light, press rear
portion of power switch (5). To turn off machine
and light, press front portion “0” of power
To run the machine and control speed, press the
speed controller (6) with foot. The harder it is
pressed, the faster the machine will sew. To stop
machine, remove foot from the controller.
NOTE: Do not operate machine without fabric
under the presser foot as this may
damage the feed and the presser foot.