Changing snap>on presser feet, Changing screw-on presser feet – SINGER 2112 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing Snap>on Presser Feet
The accessory feet supplied with the machine fit
onto a common shank and are attached easily
as follows:
^ Raise needle to highest point by turning the
handwheel towards the operator.
* Raise presser foot using lever on rear of
machine.
5k Push up on toe of presser foot (1) until it
snaps off shank (2) and remove foot.
5k Place new foot on needle plate with pin (3)
under center of shank.
5k Using presser foot Hfter, lower shank onto pin
(3) and push down firmly on presser foot screw
(4) until foot snaps into place onto shank.
Changing Screw-on Presser Feet
Special feet which have built-in shanks are
replaced as follows:
5k Raise needle and presser foot.
:k Loosen presser foot screw (4) with a coin and
remove presser foot with shank (5) guiding it
towards the operator and to the right.
5k To replace foot, hook it around presser bar
(6) and screw (4). Tighten screw with a coin.