To remove thread, To remove bobbin – SINGER 626E6 Touch & Sew User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO WtND THE BOBBIN (Continued)
To Rem©¥e Short Thread, Pull Through Throat Plate
^3-
*
O
To Remove Thread
Thread can be removed from the bobbin in either of
two ways. If there is not much thread left on the bob
bin, simply pull the thread end through the throat
plate.
If there is a lot of thread left, remove the bobbin (as
illustrated below), unscrew the two halves, and re
move all the thread at once.
To Remove Long Thread, Unscrew Two Halves of Bobbin
To Remove Bobbin
1. Turn hand wheel to raise take-up lever to its
highest position.
2. Open slide plate; leave bobbin push-button in
sewing position.
3. Raise bobbin latch by inserting fingernail under
end of latch at center of bobbin.
4. Insert fingernail under rim of bobbin immediately
to right of latch and remove bobbin.
To Remove Bobbin
U
X
Open Slide Plate and Raise Latch
Lift Out Bobbin
10