Set n eec, To set stitch length, To set selector – SINGER 626E6 Touch & Sew User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.
' SET N EEC
Meedle PosBtion Selector
Press Down
Slide
Release
The Needle Position Selector places the needle in
either left, center, or right stitching position. Yon
will need to set it for bobbin winding as well as for
straight or zig-zag stitching.
Before moving selector, be sure that needle is out of
the fabric.
Always set selector at C.
: Set selector at C.
Zig-Zag Stitchirig:
You will use
C
position most
often; L and R settings are for special stitch place
ment. For example: L setting is required for button
holes, button sewing, and two-needle work. L or R
setting is used to place narrow zig-zag stitching to the
left or right of center in decorative work.
Stitch Length Selector
Reverse
Locked Setting
Forward
Thumb Nut
6. TO SET STITCH LENGTH
The Stitch Length Selector does two jobs, which in
this case are common to both straight and zig-zag
stitching: it controls the length of stitches and the
direction of stitching (either forward or reverse).
The numbers on either side of the lever represent the
number of stitches per inch: the higher the number,
the shorter the stitch. Generally, shorter stitches are
best for lightweight fabric; longer ones for heavy
fabric. The FINE area, which represents over 20
stitches per inch, is used for zig-zag stitching.
To Set Selector
® Loosen thumb nut by turning to left.
® Position lever for desired stitch length.
® Tighten thumb nut by turning to right.
For reverse stitching,
simply raise lever as far as it
will go. Do not loosen the thumb nut to reverse
unless you are using the No. 6 setting, in the very
bottom position.
To Loosen
To Tighten