To connect machine – SINGER 626E6 Touch & Sew User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1.
TO CONNECT
MACHINE
Before plugging in your machine, be sure that the
voltage and number of cycles stamped on the four-
pin receptacle are within the range marked on the
electric meter installed by your power company.
Push the four-hole plug onto the four pins at the
right end of the machine. Then connect the two-pin
plug to your electrical outlet.
rO TURN ON M
IL
SPEED;
TURN
OFF MACHINE
LIGHT; CC
AND LIGl
Electrical Connections
To turn on both the machine
and
the
sewing light,
slide the Power and Light Switch to ON position.
P O W E R & L I G H T
OFF
O N
Power and Light Switch
To run the machine and control speed,
press the
foot controller (or knee lever) The harder you press,
the faster the machine will sew.
To turn off both the machine and the light,
return
the Power and Light Switch to the OFF position.
This unique electrical system offers several advan
tages : you see at a glance when the machine is ON
or OFF by means of the light; you can turn off the
power with the convenient switch instead of having
to unplug the machine; and since the Power and
Light Switch must be turned on before the machine
will start, there is less chance of “little hands or feet”
accidentally pressing the Foot Controller (or Knee
Lever) and starting the machine.
Foot Controller